Sonicware LIVEN 8bit warps - User Data Backup and Restoration; Backing Up User Data; Restoring User Data

Saving and loading user data
26
Backing up user data
① While pressing , press the POWER switch to turn
on the LIVEN 8bit warps.
②
Turn the
VALUE knob, and select EXPT.
③ Press
to start transfer.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The steps show the progress of data transmission.
(The step LEDs will light in order from step 1. Trans
-
mission is complete when all step LEDs 1–16 light.)
• Regardless of data transmission status,
can be pressed to cancel.
• After transmission completes, DONE will appear on
the display.
• The size of the backup data is 1,487,274 bytes.
• If the size of the data is di󱐯erent, the backup may
have failed, so turn
the
VALUE knob while press
-
ing to increase the communication interval
before step ③ .(The default value is 0.)
Restoring user data
① While pressing , press the POWER switch to turn
on the LIVEN 8bit warps.
②
Turn the
VALUE knob, and select IMPT.
③ Press
, and start data transmission from the oth-
er device.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The steps show the progress of receiving data. (The
step LEDs will light in order from step 1. Receiving
is complete when all step LEDs 1–16 light.)
• Regardless of the data reception status,
can be pressed to cancel. (Received data will be
discarded.)
④ After receiving completes, SAVE will be shown on
the display. Press
to restore the received data.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• After restoring completes, the unit will start normal
-
ly.