Sonicware LIVEN 8bit warps - Rhythm and Step Settings; Changing Note of a Single Step; Changing Pattern Length; Setting a Pre-count

Step sequencer and rhythm settings
19
Changing the note of a single step
① While pressing , press
NOTE.
②
Turn the
VALUE knob to change the note.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The note is shown on the display.
• Notes can be set to 1/1, 1/2, 1/4., 1/4, 1/8., 1/2T,
1/8, 1/16., 1/4T, 1/16, or 1/32. (A . indicates a dot
-
ted note, and a T indicates a triplet length.)
Changing the pattern length
① While pressing , press
LENGTH.
② Turn the
VALUE knob to change the length.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The length is shown on the display.
• The adjustment range is 1–128.
Setting a pre-count
① While pressing , press PRE COUNT.
②
Turn the
VALUE knob to change the pre-count.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The count number is shown on the display.
• The adjustment range is 0–8.
• The volume of the pre-count is the same as for the
metronome. (See p.28“Adjusting the metronome
volume”.)