Sonicware LIVEN 8bit warps - Adjusting the Looper; Adjusting Looper Track Levels; Adjusting Looper Track 4 and External Input Level; Adjusting Looper Track Panning

Adjusting the looper
22
This section explains adjustments related to the looper.
Explanations assume that looper mode has already been
enabled
Adjusting looper track levels
①
Turn
Main knobs 1–3.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The levels are shown on the display.
• The adjustment range is 0–127.
• They can be adjusted from －∞ to +6 dB with 0 dB
as the middle values (63–64).
•
The
Main knobs correspond to the tracks as fol
-
lows.
Main knob 1 : Looper track 1
Main knob 2 : Looper track 2
Main knob 3 : Looper track 3
Main knob 4 : Looper track 4
• After recording completes, looper track volume will be
reset.
Adjusting the level of looper track 4 and
the external input
①
Turn
Main knob 4.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• If looper track 4 has recording data, turn
Main
knob 4 to crossfade between looper track 4 and the
external input. (Turn
Main knob 4 all the way to
the right to maximize the level of looper track 4 and
make the external input level 0. Turn it all the way
to the left to minimize the level of looper track 4
and maximize the level of the external input.)
• The moment looper track 4 recording completes,
the external input level becomes 0 and looper track
4 level is maximized (as though turned all the way
to the right).
• If Looper track 4 has no recording data, the external
input level depends on the gain setting value.
Adjusting looper track panning
① While pressing , turn
Main knobs 1–4.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The panning is shown on the display.
• The adjustment range is L63–CNTR–R63.
•
The
Main knobs correspond to the tracks as fol
-
lows.
Main knob 1 : Looper track 1
Main knob 2 : Looper track 2
Main knob 3 : Looper track 3
Main knob 4 : Looper track 4
• After recording completes, looper track volume will be
reset.
Changing looper quantization
① While pressing , press the keyboard LOOP key,
and select QNTZ.
②
Turn the
VALUE knob to change the quantization.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The quantization is shown on the display.
• The adjustment range is 1–128.
Changing looper length
① While pressing , press the keyboard LOOP key,
and select LEN.
② Turn the
VALUE knob to change the length.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
• The length is shown on the display.
• The adjustment range is 1–128.