SONOVE M2-M - Safety Instructions

M2-M Operating Manual | Safety Instructions
M2-M_Operating_Manual_2.0.0
7
2 SAFETY INSTRUCTIONS
The following safety instructions and warnings on the product must be read carefully to prevent injury to people
and damage to property.
WARNING: Assure that the personnel responsible for installation and operation of this product has
carefully read and understood the operating instructions, related documents as well as the safety
and regulatory information!
· Local regulations and directives for occupational safety and prevention of risks and accidents as well as
general safety instructions must be taken in consideration.
· All safety instructions and warnings on the device must be observed.
· The information on the type label must be observed.
WARNING: Use of controls, adjustments, procedures, connections, or signal types other than those
specified in the product documentation may result in exposure to shock, electrical hazards, and/or
mechanical hazards.
WARNING: Do not open the product! Opening the product may cause electric shock or hazard, fire,
product damage and/or severe or fatal injuries!
· Do not attemp to service the product yourself!
· Maintenance, service and repair must be performed by the manufacturer or instructed, qualified
personnel, in consultation with the manufacturer!
WARNING: Do not make any modifications to the product! Modifying the product may change the
product behavior (e.g. EMC) and/or cause electric shock or hazard, fire, product damage and/or
severe or fatal injuries!
WARNING: Do not use non-approved, non-certified or damaged spare parts and accessories! Using
non-approved, non-certified or damaged spare parts and accessories may cause electric shock or
hazard, fire, product damage and/or severe or fatal injuries!
WARNING: Non-compliance with the specified conditions or stress beyond conditions of ordinary
use may cause electric shock or hazard, fire, product damage and/or severe or fatal injuries!
· The product must be brought to ambient temperature before it is started up. If condensation forms,
ensure dryness of operator panel before connecting to the power outlet!
· Only install and operate the product under the specified conditions (cf. Technical Specification). Do not
expose product to mechanical stress that exceeds conditions of ordinary use!
· Do not drop the product!
· Do not push any objects into openings of the product!
WARNING: Sufficient heat dissipation and ventilation for the product must be ensured! Product
overheating may cause electric shock or hazard, fire, product damage and/or severe or fatal injuries!
· Do not install the product close to heat sources (e.g. radiators, heaters)!
· Do not expose product permanently to direct sunlight!