14 Instruction for use | Supercal 5
4. Installation
Installation and commissioning of a heat measuring point should only be carried out by au-
thorised, specialist personnel in compliance with the appropriate standards and local safety
and installation regulations.
According to EN 1434-2 and EN 1434-6, the installation guidelines must be followed. A heat
measuring point will only meet the planned accuracy and reliablity requirements if these
are complied with.
4.1 Acceptance of Goods
After receiving the goods, check:
The packaging and contents are not damaged
The delivered product is complete
Compare the scope of delivery with your order details.
4.2 Transporting and Storing the Calculator
can be found in the chapter Technical Information.
Observe the following points:
For storage and transport the device must be protected against impact damage. The
original packaging offers optimum protection for this.
should be limited to maximum 48 hours.
4.3 Checking the Scope of Delivery
Check the scope of delivery for completeness and possible damage. Contact your dealer or
Sontex SA in case of faulty delivery.
4.4 Structure and Components of the Calculator
The Supercal 5 calculator consists of:
A cover section, containing measuremant and calibration components
A lower, body section
The calculator’s modular design allows for low storage costs and simple and effective meter
replacement after the calibration validity has expired.
Only the cover section of the calculator needs to be replaced, the body section of the
remains in situ.
To Next Page
Loading...
Need help?
General
