46 Instruction for use | Supercal 5
7.3.1.3 Power Supply
Either batteries or power supply modules can be used. The type of power supply can be con-
verted at any time. The Supercal 5 automatically detects the type of power supply installed.
7.3.1.4 Error Output
The error output can be used as an alarm contact to signal the freely selectable error states
of the heat meter.
The error outputs are programmed using the Superprog Windows.
An error output becomes active if at least one of the selected error messages of the heat
meter is present.
The event is stored with its time, date, value and event number.
8. Maintenance
No exceptional maintenance work is required for the electronic device.
8.1 Cleaning
The front of the housing can be cleaned with a dry, soft cloth
9. Troubleshooting
For service requests, please have the serial number of the device and the
error number ready!
Please always state the error number and the Service menu’s information
requests.
The Service menu is used to analyze the device functions and offers comprehensive assis-
9.1 General Troubleshooting Procedure
If this doesn’t lead to success, please contact your Sontex representative. The contact de-
tails can be found on the Internet at www.sontex.ch/contact/.
9.2 Fault Indication
All error messages are automatically cleared on the LCD display 60 seconds
after troubleshooting.
The Supercal 5 displays the errors on the LCD with a description.
To Next Page
