Sontex Supercal 5 I User Manual

58 Instruction for use | Supercal 5
13. Appendix
13.1 Extra Information for Supercal 5 S
13.1.1 The “Cut Off” Function of the Superstatic 440

-

The “cut off” function can only be stored in the calibration and measurement relevant part
of the Supercal 731 by violating the calibration seal.

place. Therefore, no volume is cumulated.


message event will be recorded.

heating system, e.g. system vibrations. This makes the measurement less sensitive, which
makes it easier to isolate a possible erroneous measurement.

customized by Software in Supercal 5 Calculator with verier level user.
Note

The threshold values of the “cut off” function are to be regarded as

standard (Qa and Qmin). However, the “cut off” value must not exceed
Qmin.
Qa Qmin Qt Qn Qmax
Qi (OIML)
0
''Cut off'' ''Flow saturation''

Sontex Supercal 5 I Specifications

General

Power supply	3.6 V Lithium battery
Measuring principle	Ultrasonic
MID approval	Yes
Communication interfaces (optional)	M-Bus, LoRaWAN
Measurement Accuracy	Class 2 (EN 1434)
Pipe Diameter Range	DN15 to DN40
Outputs	Pulse output
Nominal flow rate qp	1.5 m³/h