Sontex Supercal 5 - Manufacturer Notices and Security; Customer Correction Curve Sticker; Manufacturers Configuration Notes; Security Seal Purpose and Application

38 Installation guide | Supercal 5
Security seals
Seals are country specic; the local regulations must be respected. Against
possible manipulation or unauthorized dismantling, the thermal energy meters,
the screw connections, as well as the temperature sensors and pockets must
be protected with user seals. The seals may be removed only by authorized
persons. By neglecting this precaution the guarantee obligation is void. It is
important that the seal wires are kept as short as possible and are well strained
towards the seals. Only this way, the seal is protected against unauthorized
interference.

If a customer specic correction curve is applied, a sticker must be placed on
the cover of the calculator and completed with the serial number of the sen-
sor head. Replacement of the sensor head, as it is described in the homologa-
tion, isn’t possible in this case.
Manufacturer’s notice:
The heat / cooling meter Superstatic 5 S is congured and adjusted ex factory
to the different sizes of uid oscillator ow sensors. An optimal measuring
accuracy and stability according to EN 1434 class 2 is guaranteed and a free
swapping of the sensor head is possible.
Sontex declines all responsibility on specic correction curves of the uid
oscillator ow sensors that we’re not dened by Sontex.