7-1
BDP-BX2/S360
SECTION 7
SERVICE MODE
Main Functions
- Starting Service Mode
To start Service Mode, while the AC power is off, turn on the AC power while holding down a specific key (PLAY key, STOP key, or
OPEN/CLOSE key) on the front panel of the unit. Release the key when “SERVICE” appears on the front display panel. Startup is
completed when the Service Mode screen is displayed on the monitor. Use the remote control to perform operation.
- View ErrorLog/CommandLog
This displays the error log or command log. The displayed information can also be saved to a USB memory device.
- Diag (Diagnostics)
This performs individual tests on devices installed on the board.
- Drive (Drive-related diagnostics and tools)
These are tools for performing diagnostics on the BD-Drive and writing of operation data. (For details on the menu options, refer to the
separate documentation.)
- Factory Initialize (Factory default settings)
This returns the set to the factory default settings.
-Network
This checks the network connection.
1. “Ifconfig” is used to display the network settings of the set unit.
When this is executed, the #ifconfig command is executed, and the command execution results are displayed.
2. “Ping” is used to check network connectivity with the terminal specified by the IP address.
When this is executed, the #ping command is executed, and the command execution results are displayed.
- Version Up (Version update)
This updates the version using an update disc. For details on version updating, refer to the separate documentation.
- System Information
This displays the system information of this set. Information about the software version and drive is displayed.
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
