ICD-UX71/UX81/UX71F/UX81F/UX91F 4-114-023-41(1)
98
GB
Symptom Remedy
The operation indicator
does not light.
“LED” is set to “OFF” (page 70). Display the menu and set “LED”
to “ON.”
“MEMORY FULL” is
displayed and you cannot
start recording.
The memory is full. Erase some of the messages (page 52) or
erase all the messages after you store them on your computer.
“FILE FULL” is displayed
and you cannot operate
the IC recorder.
99 messages have been recorded in the selected folder or
495 messages (when there are 5 folders) in total have been
recorded. Therefore you cannot record another message, or
move a message. Erase some of the messages (page 52) or
erase all the messages after you store them on your computer.
Recording is interrupted. The VOR function (page 30) is activated. Set “VOR” to “OFF” in
the menu (page 64).
Noise is heard. An object, such as your nger, etc., accidentally rubbed or
scratched the IC recorder during recording so that noise was
recorded.
The IC recorder was placed near an AC power source, a
uorescent lamp or a mobile phone during recording or
playback.
Plug of the connected microphone was dirty when recording.
Clean the plug.
The (headphones) plug is dirty. Clean the plug.
Recording level is low. “MIC SENSITIVITY” (microphone sensitivity) is set to “LOW (L).”
Display the menu and set “MIC SENSITIVITY” to “HIGH (H)”
(page 28).
To Next Page
Loading...
