Sony CDP-C910 - Advanced Time Edit Features; Adding Selections (Link); Program Playback and Control

You can designate a time and the unit will make 2
different programs of selections each fitting within that
period. Use this function, by designating the length of your
tape, for editing both sides of a tape.
To add selection(s) — LINK —
After all selections on the disc have been programmed, if
there is selection(s) within the remaining time, “LINK” and
the selection number(s) will blink.
sprocram m
Ml
ws @2 345678 9 0% iT Jal Is
Déc TRACK - sc 7
To add selection, press the numeric button for the
selection number or press the EDIT/TIME FADE again.
When pressing the EDIT/TIME FADE, a program will be
made automatically to fit the playing time as close as
possible to the remaining time.
If the remaining time can contain other selection(s),
"LINK" and the selection number keep blinking. When
“LINK” blinks, if the disc is changed by another disc, the
new selection number(s) on the new disc that fit in the
remaining time will blink.
"EDIT" disappears when the playing time becomes equal
to the designated time. Whether “LINK” is blinking or not,
you can change the disc by another disc and choose
selection(s) to fit the remaining time.
To cancel the "EDIT" display in the window, press the lI
button.
To play the program
Press >.
The selections for side A will be played and then the unit
will pause. "B" lights up in the tape side indicator. Set the
tape to the beginning of side B, then press » or II.
The selections for side B will be played.
Note
Playback can be performed when “EDIT” is displayed.
To stop playing
Press Bl
You can play the same program repeatedly as long as you
do not erase the program.
To cancel time edit
Press CONTINUE and return to the continuous playing mode.
The program will be erased.
To erase the entire program
Press W once during stop; twice during play.
Press W twice when "EDIT" appears in the display during
the stop mode.
The program is aiso erased, when you turn off the unit or
press &.
To include desired selections in the program
1 Make you own program of the desired selections.
See page 14 for instructions.
2 Follow the procedure as shown on the preceding page.
Just designate the length of your tape; you need not
subtract the length of your program. The unit will place
your selections at the beginning of its program and add
other selections to fit the remaining time.
Checking the programmed selection
See page 15.
To designate a different time for each side
Execute steps 1 to 4 and press Il Then repeat steps 2 and 4.
Do not execute step 5.
If your disc has more than 20 selections
* Selections over 20 cannot be programmed with the time edit
function.
* |f the program already contains a selection over 20, the time
edit function will not work.
Notes
* Up to 32 steps will be programmed. Furthermore, the time edit
function cannot be used if your program has 32 steps.
* Time edit will not work for programs with total playing times
exceeding one hour.
17