Sony CDP-C910 - Disc Memo Functionality; Assigning Disc Names; Usable Characters and Editing

Assigning Names to a Disc - Disc Memo
2 Choose the disc.
DISC SKIP
Make sure that the total number of selections and
the total playing time are displayed. Then proceed
as follows in the stop mode,
[A] Using the MEMO INPUT button with the letter
buttons on the remote commander (This
function can be entered while playing)
p CONTWUE
1 MEMO INPUT
xs 0000000000
Each time you press MEMO INPUT, the display
changes as shown above. Choose the desired
capital letters, or numbers.
2 Press the applicable letter button.
=æ LJ
Disc 6
Ld > Ld
mes 000090000039
DT
Move the cursor to select the next letter.
To change to numbers, return to the step [A] -1.
22
Using the </>» buttons
1 I=)
e
e CONTINUE
A
NE
ZN
Press < or BP until the desired letter
appears.
Example: if > is pressed 7 times, F appears.
2 When the desired letter appears, press PPI.
a CONTINUE
x ODD DOODOOS
= l,
Move the cursor to select
the next letter.
Repeat steps [B] -1 and [B] -2.
= CONTINUE
as 0000000000
After about 1 second, the memo you have written
will be displayed.
Each time the disc is put in the unit, the memo will
be displayed.
Note
Symbols cannot be entered with the letter buttons on the remote
commander. To enter symbols, use <4<4/ buttons.