Sony CDP-C910 - Peak Search Function; Peak Search Operation Modes; Activating and Controlling Peak Search

Locating the loudest portion of _
the disc - Peak Search Fi
This unit can search a disc from the beginning to the end
and determine the loudest portion (peak level) of the disc,
and then play that portion repeatedly. This function will
make it easier for you to adjust to the optimum level when
recording on tape.
This function operates in all play modes as follows:
Play mode Operation
Continuous and Searches all selections on the disc
shuffle modes that is currently clamped.
Program mode Searches all programmed selections
Bank mode Searches all programmed selections
on the disc that is currently
clamped.
Unless you are using the program mode, the unit will scan
all discs that are clamped, even in the ALL DISCS mode.
To activate the peak search
Press P.SEARCH during the stop mode.
“PEAK” flashes in the display and the all selection of the
disc or program will be searched automatically. After
finishing the search, ‘“- PEAK -" is displayed and the
loudest portion is played repeatedly for 4 seconds.
Note
To go to another disc press DISC SKIP button during stop.
To start play immediately
Press We. The play starts from the beginning of the disc.
To stop the peak search
Press B.
Press Îi to pause at the first selection.
Note on peak search function
The unit determines the loudest portion (peak level) of a disc
by searching it at fixed intervals. As a result, the portion
searched may differ from the actual peak level. In addition, this
function may determine different portions as the peak level for
the same disc. However, the difference between the portion
searched and the actual peak level is insignificant and will not
present any problem in adjusting the recording level.
19