Sony CDP-C910 - Connections; Connection Best Practices; Amplifier Connectivity

Connections
For Correct Connections
* Turn off the power of each unit before making
connections.
* Connect the AC power cord last.
* Be sure to insert the plugs firmly into the jacks.
Loose connection may cause hum and noise.
Optical Digital Out
To Connect to an Amplifier
* Leave a little slack in the connecting cord to allow for
inadvertent shock or vibration.
* Cord plugs and jacks are color coded: Red plugs and
jacks are for the right channel (R) and white ones for the
left channel (L).
When connecting to an amplifier
or D/A converter with OPTICAL
IN, use OPTICAL DIGITAL OUT
instead of LINE OUT.
jal == Take off
«242, the cap
*
LINE OUT
jal
Plug in firmly
qu
TA
——— m To AC outlet
Speaker system
SPEAKER
a
=> To wall outlet
*Notes on LINE OUT
FIXED: The output level is fixed.
VARIABLE: The output level can be adjusted with PHONE
LEVEL/LINE OUT LEVEL control or LINE
OUT LEVEL buttons on the remote
commander. However, if the PHONE
LEVEL/LINE OUT LEVEL control is turned
while recording, the recording level will change
even when it is preset on the tape deck.
Note on optical digital out
Connect the optical out to the amplifier with the optical
input or D/A converter. When you connect, use the
connecting cable for optical out POC-15 (not supplied).
When the optical out is connected, you cannot use fade
out, fade in and time fade function.