Radio
Storing
and
receiving
stations
Caution
When tuning
in
stations while boating, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically - BTM
1 Press
(SOURCE)
repeatedly until
"TUNER" appears.
To change the band, press
(MODE)
repeatedly.
You
can select from
FM
I, FM2,
FM3, AM I
or
AM2.
2 Press and hold
(BTM)
until "BTM"
flashes.
The
unit stores stations in order
of
frequency
on the number buttons.
A beep sounds when the setting is stored.
Storing manually
1 While receiving the station that you
want to store, press and hold a
number button
(CD to
®)
until
_ "MEM" appears.
The
number button indication appears in the
display.
Note
If
you try
to
store another station on the same number
button, the previously stored station will
be
replaced.
Receiving the stored stations
1 Select the band, then press a number
button
(CD to
®).
Tuning automatically
1 Select the band, then press
(SEEK)
-1+
to search for the station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station
is
received.
Tip
If
you know the frequency
of
the station you want
to
listen
to,
press
and
hold (
SEEK)
-/+
to locate the
approximate frequency, then press
(SEEK)
-/+
repeatedly to fine adjust to the desired frequency
(manual tuning).
12
For details on selecting a
CD
changer, see
page
19.
Playing
a
disc
1 Slide the OPEN switch
in
the direction
of the arrow.
2 Open the front panel.
3 Insert the disc (label side up).
4 Close the front panel.
Playback starts automatically.
Notes
• Do not
put
anything on the inner surface
of
the front
panel.
• Be sure
to
close the front panel during operation.
Ejecting the disc
1 Slide the OPEN switch and open the
front panel.
2
Press~.
The disc is ejected.
3 Close the front panel.
To Next Page
Loading...
