Tone
controls:
Low: ±lO dB
at
60 Hz (XPLOD)
Mid: ±lO dB
at
I
kHz
(XPLOD)
High: ±IO dB at
lO
kHz (XPLOD)
Power
requirements:
12
V DC boat battery
(negative ground
(earth»
Dimensions:
Approx. 197 x 89 x 187 mm
(77
18
x 3
5
18
x 7 3/8 in) (w/h/d)
Mounting
dimensions:
Approx.
181
x 52 x 144 mm
(7
1
/4
x 2 1
/8
x 5 3/4 in) (w/h/d)
Mass:
Approx. 1.8 kg (4 lb)
Supplied
accessories:
Card remote commander: RM-X
15
I
Parts for installation and connections
(l
set)
Optional
accessories/equipment*:
Marine remote commander: RM-X60M,
RM-XIIM
Rotary commander: RM-X4S
BUS cable (supplied with an RCA pin cord):
RC-6 I (I m), RC-62 (2 m)
CD changer (10 discs): CDX-757MX
CD
changer (6 discs): CDX-T69
Source selector: XA-C40
AUX-IN selector: XA-300
USB connection cable for iPod: RC-lOOIP
HD Radio
™ tuner: XT-I
OOHD
* Accessories/equipment other than the marine
remote commander RM-X60M/X11M are
not
waterproof. Do not subject them
to
water.
Your
dealer
may
not
handle
some
of
the
above
listed
accessories.
Please
ask
the
dealer
for
detailed
information.
Design
and
specifications are subject
to
change
without notice.
• Halogenated flame retardants are not used
in
the
certain printed wiring boards.
• Halogenated flame retardants are not used
in
cabinets.
• Packaging cushions are made from paper.
Troubleshooting
The
following
checklist
will
help
you
remedy
problems
you
may
encounter
with
your
unit.
Before
going
through
the
checklist
below,
check
the
connection
and
operating
procedures.
If
the
problem
is
not
solved,
visit
the
following
support
site.
Support
site
For
customers
in
the
U.S.A.
and
Canada:
http://esupport.sony.com
http://www.xplodsony.com/
For
customers
in
Europe:
http://support.sony-europe.com
For
customers
in
Latin
America:
http://esupport.sony.com/ES/LAJ
For
customers
in
Pan
Asia:
http://www.sony-asia.com/section/support
http://www.sony-asia.com/caraudio/
No
power
is
being
supplied
to
the unit.
• Check the connection
or
fuse.
•
If
the unit is turned off and the display disappears,
it
cannot be operated with the remote commander.
..
-+
Turn on the unit.
The power antenna (aerial)
does
not
extend.
The power antenna (aerial) does not have a relay box.
No sound.
• The ATT function is activated,
or
the Telephone ATT
function (when the interface cable
of
a telephone is
connected to the ATT lead) is activated.
• The position
of
the fader control "FAD" is not set for
a 2-speaker system.
No beep sound.
• The beep sound is canceled (page 18).
• An optional power amplifier is connected and you are
not using the built-in amplifier.
The
contents
of
the
memory
have been erased.
• The RESET button has been pressed.
-+
Store again into the memory.
•
The
power supply lead
or
battery has been
disconnected
or
it
is not connected properly.
Stored
stations
and
correct
time are erased.
The
fuse
has blown.
Makes noise when
the
position
of
the
ignition
is
switched.
The leads are not matched correctly with the boat's
accessory power connector.
continue
to
next
page-+
23
To Next Page
Loading...
