Maintenance
Specifications
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose
of
in
fire.
Power amplifier section
Outputs:
Speaker outputs (sure seal connectors)
Speaker
impedance:
4 - 8 ohms
Maximum
power
output:
52 W x 4 (at 4 ohms)
USB Player section
Interface:
USB (Full-speed)
Maximum
current:
500mA
CEA2006 Standard
Power Output:
17
Watts RMS x 4
at
4 Ohms <
1%
THD+N
SN Ratio: 82 dBA
(reference:
I Watt into 4 Ohms)
General
Outputs:
Audio outputs terminal (front/rear)
Subwoofer output terminal (mono)
Power antenna (aerial) relay control terminal
Power amplifier control terminal
Inputs:
Remote controller input terminal
Antenna (aerial) input terminal
Telephone
ATT
control terminal
Illumination control terminal
BUS control input terminal
BUS audio input terminal
AUX input terminal
USB signal input terminal
CD Player section
Signal-to-noise ratio: 120 dB
Frequency
response:
10
- 20.000 Hz
Wow
and
flutter: Below measurable limit
Tuner section
FM
TIming range:
87.5 - 108.0 MHz (at 50 kHz step)
87.5 - 107.9 MHz (at 200 kHz step)
FM
tuning
interval: 50 kHz/200 kHz switchable
Antenna
(aerial)
terminal:
External antenna (aerial) connector
Intermediate
frequency: 150 kHz
Usable sensitivity:
10
dBf
Selectivity:
75
dB
at
400 kHz
Signal-to-noise ratio: 70
dB
(mono)
Separation:
40 dB at I kHz
Frequency
response: 20 - 15,000 Hz
AM
TIming
range:
531
- 1,602 kHz (at 9 kHz step)
530 - 1,710 kHz (at
10kHz
step)
AM
tuning
interval: 9kHz/10kHz switchable
Antenna
(aerial)
terminal:
External antenna (aerial) connector
Intermediate
frequency:
25
kHz
Sensitivity: 26
tJ
V
AUDIO POWER SPECIFICATIONS
~
~
Fuse (10 A)
Fuse replacement
When
replacing the fuse, be
sure to use
one
matching
the
amperage
rating stated on the
original fuse.
If
the fuse blows,
check
the
power
connection
and
replace the fuse.
If
the fuse
blows again after replacement,
there
may
be an internal
malfunction. In such a case,
consult
your
nearest
Sony
dealer.
Notes on the
lithium
battery
• Keep the lithium battery out
of
the reach
of
children.
Should the battery be swallowed, immediately
consult
a doctor.
• Wipe the battery with
a dry cloth
to
assure a good
contact.
• Be sure
to
observe the correct polarity when
installing the battery
•
00
not hold the battery with metallic tweezers,
otherwise
a short-circuit may occur.
Replacing the lithium battery of the
card remote commander
Under
normal conditions, the battery will last
approximately
I year.
(The
service life may
be
shorter.
depending
on the conditions
of
use.)
When
the battery
becomes
weak, the
range
of
the
card remote
commander
becomes
shorter. Replace
the battery with a new
CR2025
lithium battery. Use
of
any
other
battery may
present
a risk
of
fire
or
explosion.
22
•
To Next Page
Loading...
