iPod
For details on the compatibility
of
your iPod, see
"About iPod" on page
21
or
visit the support site.
In
these Operating Instructions, "iPod" is used as
a general reference for the iPod functions on the
iPod and iPhone, unless otherwise specified by
the text
or
illustrations.
Support site
For customers
in
the U.S.A. and Canada:
http://esupport.sony.com
http://www.xplodsony.com/
For customers
in
Europe:
http://support.sony-europe.com
For customers
in
Latin America:
http://esupport.sony.com/ES/LAI
For customers
in
Pan
Asia:
http://www.sony-asia.com/section/support
http://www.sony-asia.com/caraudio/
~Iaying
back
i~od
Before connecting the iPod, turn down the
volume
of
the unit.
1 Remove the USB cap from the USB
connector and connect the iPod to the
USB connector via the dock connector
to USB cable.
The iPod will tum on automatically, and the
display will appear on the iPod screen as
below.*
The tracks on the iPod start playing
automatically from the point last played.
If
an iPod is already connected,
to
start
playback press
(SOURCE)
repeatedly until
"USB"
appears. ("IPD" appears
in
the display
when iPod is recognized.)
*
If
the iPod was played back in the passenger control
last time, this will not appear.
2 Press
(MODE)
to select the play mode.
The mode changes as follows:
RESUMING
--+
ALBUM
--+
TRACK
--+
PODCAST*
--+
GENRE
--+
PLAYLIST
--+
ARTIST
* May not appear depending on iPod setting.
3 Adjust the volume.
Press
(OFF)
to stop playback.
Removing the iPod
1 Stop the iPod playback.
2 Remove the iPod.
Caution for iPhone
When you connect an iPhone via
USB,
telephone
volume
is controlled
by
iPhone itself. In order
to
avoid
sudden loud sound after
a call, do not increase the
volume on the unit during
a telephone call.
Note
This unit cannot recognize iPod
via
a USB hub.
~s
..
•
We
recommend the RC-1001P USB cable (not
supplied)
to
connect the dock connector.
• When the ignition key is turned
to
the ACC position,
and
the unit is on, the iPod will be recharged.
•
If
the iPod is disconnected during playback, "NO
DE
V"
appears
in
the display
of
the unit.
Resume mode
When the iPod is connected to the dock
connector, the mode
of
this unit changes to
resume mode and playback starts in the mode set
by the iPod.
In
resume mode, the following buttons do not
function.
- ® (REP)
-
8)
(SHUF)
15
To Next Page
Loading...
