Sony DCR- - Step 1 Preparing the Power Supply; Installing the Battery Pack

18
Installing the battery pack
(1) Lift up the viewfinder.
(2) Slide the battery pack down until it clicks.
To remove the battery pack
(1) Lift up the viewfinder.
(2) Slide the battery pack out in the direction of the arrow while pressing the
BATT (battery) release lever down.
If you install the large-capacity battery pack
If you install the NP-FM70/QM71/QM71D/FM90/FM91/QM91/QM91D battery pack
on your camcorder, extend the viewfinder.
Step 1 Preparing the power supply
1
2
BATT (battery)
release lever