114
Chaper 4 Operation Tips
Chapter 4 Operation Tips
Basic Operation Procedure
During the duration specified by the punch in/out
function, the minimum level is stored as automation
data for the corresponding fader.
At the punch in point, the current fader level is stored.
At the punch out point, the fader level of the previous
data is resumed.
When the events have been completed and everything
is ready to save as data, select KEEP by touching the
TITLE button on the window, as required.
Performing punch in/punch out using the
foot switch
Punching in/punching out using the foot switch allows
you to manually control the Drop in/out using an
external foot switch.
To perform a cut operation, use the AUTOMATION
buttons section on the Automation panel on the unit
and in the AUTOMATION window.
For details of buttons, see “Automation Panel” on page 26,
and for operations on the window, see “AUTOMATION
Window” on page 77.
1 Select the FOOT SW button on the PUNCH IN/
OUT section on the AUTOMATION window.
2 Press the ABS button on the TC AUTOMATION
section on the Automation panel of the unit so that
it lights up.
3 Set the fader or other control for the signal you
want to cut to READY mode.
4 Drop in the fader in the window.
The display turns in red, but data will not be
written until the foot switch is set to ON.
5 Press the SAFE button on the TC AUTOMATION
section on the Automation panel of the unit so that
it is off.
6 Locate the tape recorder at a point a little before
the PUNCH IN time and play.
7 Slide the faders up to the desired level.
8 Set the foot switch to ON at the desired time.
9 Stop the tape recorder at the right point, or switch
the foot switch to OFF.
Using the Audition Mode
When the AUDITION mode is set to ON, you can
safely readjust the mix balance repeatedly. This mode
will be usable for fine adjustment of mix balance.
1 Touch the AUDITION button in the
AUTOMATION window.
The console enters WRITE HOLD, TOUCH
HOLD modes automatically, and the SAFE button
is ON (lit).
2 Set the AUTO RETURN TIME as desired.
Note that the AUTO RETURN TIME setting is
effective only when you set the SAFE button OFF
and stop the timecode.
3 Select the AUTOMATION mode.
4 Set the automation item to be adjusted to READY.
5 Start the tape recorder, and adjust the mix balance
while monitoring the sound.
6 Drop in the item as desired.
7 Repeatedly adjust the mix balance until it is
satisfactory by rewinding the tape as required.
8 After adjusting the level, rewind the tape.
9 Play the tape and set the SAFE button to OFF at
the desired automation punch in point.
The new settings will be recorded.
To Next Page
Loading...
Need help?
General
