50
GB
Remote control
Built-in battery pack
Symptom Check item Cause/Solutions
Nothing happens
even if you operate
the remote control.
• Is the battery inserted in the
remote control properly?
c Replace the battery. (page 9)
c Insert a battery. (page 9)
c Insert a battery in the proper orientation.
(page 9)
—
c Point the top end of the remote control
towards the remote sensor on the photo
frame. (page 9)
c Remove any obstruction between the
remote control and the remote sensor.
• Is there a protective sheet
inserted?
c Remove the protective sheet. (page 9)
• Is the AC adaptor connected
correctly?
c The 1 (standby) button on the remote
control cannot be used when the photo
frame is powered only by the built-in
battery pack. Use the 1 (standby) button
on the photo frame.
Symptom Check item Cause/Solutions
Cannot charge the
built-in battery
pack.
• Is the standby indicator lit? c If an internal temperature of the photo
frame rises owing to direct sunlight, etc.,
battery charging becomes disabled. In
such a case, the standby indicator does not
light, but this is not a malfunction of the
photo frame.
To Next Page
Loading...
