Sony HVR-V1E - Focusing on a Distant Subject (Focus Infinity); Recording an Index Signal

50
L:\SONY\PV\CX91030\1130insatuPDF\2887521121_GB\2887521111HVRV1UVIN\01GB05BAS.
fm
HVR-V1E/V1P
2-887-521-12(1)
5 Select [OK] by turning the SEL/
PUSH EXEC dial B, then press
the dial.
6 Press the MENU button A to hide
the menu.
z Tips
• Shot transition is assigned to the ASSIGN
buttons 1, 2 and 3 (p. 52). Cancel the shot
transition assignment to return to the pre-setting
assignment.
• To cancel the shot transition, select [SHOT
TRANS] t [YES] in step 3.
b Note
• [FOCUS INFNTY] is only available during the
manual focus. It is not available during the auto
focus.
1 Assign [FOCUS INFNTY] to one of
the ASSIGN buttons (p. 49).
2 Press the ASSIGN button
assigned to [FOCUS INFNTY].
appears.
If you release the switch, it returns to
manual focusing.
Use this function to record a distant
subject when the focus is automatically
set on a close subject.
If you make an index for a scene, you can
easily search for the scene later (p. 56).
The index function will make it easier to
check the transition of recording or edit
your pictures using index signals.
1 Assign [INDEX MARK] to one of
the ASSIGN buttons in advance
(p. 49).
2 Press the ASSIGN button
assigned to [INDEX MARK].
When pressed during recording
appears for about 7 seconds and an
index signal is recorded.
When pressed during standby
flashes.
After you press the REC START/STOP
button to start recording, appears
for about 7 seconds and an index signal
is recorded.
To cancel the operation
Before starting to record, press the ASSIGN
button assigned to [INDEX MARK] again.
b Note
• You cannot record an index signal on a recorded
tape afterward.
Focusing on a distant subject
(Focus infinity)
Recording an index signal
Assigning the functions to the ASSIGN buttons (Continued)