Sony ICF-SW77 - Recording Broadcasts; For LW;MW;SW Reception; To start recording at the desired time

For LW/MW/SW Reception
You can record radio programs by connecting a tape recorder
to the LINE OUT jack as illustrated below Use the RK-G135
Use the wide range antenna AN-1 or AN-102 {not supplied). connecting cord (not supplied) for monaural recording, or RK-
There are two methods. Gl34 < n ot supplied) for FM stereo recording.
Method A Tune in the desired station and start recording on the tape
With a connecting cord, connect the OUTPUT jack of the recorder.
antenna controller (supplied with the AN-1 or AN-102) and the The volume control setting on the radio has no effect on the
AM EXT ANT jack of the ICF-SW77. recording.
Note: For FM stereo recordings you must connect the ear-
Method B (For LW/MW reception only) phones to the PHONES jack. Otherwise the sound cannot be
1 With a connecting cord, connect the OUTPUT jack of the recorded in stereo,
antenna controller and the INPUT jack of the antenna
coupler (supplied with the AN-1 or AN-102).
2 Put the antenna coupler near the 1CF-SW77
Example: When the AN-1 is used.
You can start recording at the desired time by connecting the
Sony TCM-27 or TCM-77 cassette-corder (not supplied) to the
LINE OUT and REMOTE jacks as illustrated below. Use an
RK-G69 and an RK-G135 connecting cords (not supplied) and
a PC-261 M plug adaptor (not supplied).
Notes
• When receiving MW or LW broadcasts without and external
antenna, be sure to disconnect a SW external antenna.
Otherwise, you cannot receive them as the built-in ferrite
bar antenna does not function.
> Never connect a ground wire to a gas pipe. Doing so could
cause a fire.
■ II there is lightning, do not touch the wire of an external
antenna and disconnect its AC power adaptor (if con¬
nected) immediately. Never touch the antenna wire during a
lightning storm.
• When using an external antenna, retract the telescopic
antenna.
■ Locate the outdoor antenna as far away from the street as
possible.
> For details about the external antenna, refer to its instruc¬
tion manual.
1 Tune in the desired station.
2 Set the Timer (page 27).
3 Set the standby function of the cassette recorder.
For details, see the operating instructions of the cassette-
corder.
Note on recording with the timer
You cannot start recording a) a desired ume if you use :ne cassette-corder not
equipped with The timer standby switch
To start recording at the desired time
30
ICF-SW77