Sony MCC-3000MT - Page 35

Picture Profiles
35
Shooting
AE
Specifying operating
conditions of the AGC
Level
–2.0 / –1.5 / –1.0 / –0.5 / ±0 /
+0.5 / +1.0 / +1.5 / +2.0
–1.0: PP5
+0.5: PP6
Set the target level (to make brighter or darker) of
AGC and Auto Shutter control.
+2.0: Approx. two stop further open
+1.5: Approx. one and half a stop further open
+1.0: Approx. one stop further open
+0.5: Approx. half a stop further open
±0: Standard
–0.5: Approx. half a stop further closed
–1.0: Approx. one stop further closed
–1.5: Approx. one and half a stop further closed
–2.0: Approx. two stop further closed
Mode
Backlight / Standard /
Spotlight
Set the control mode for AGC and Auto Shutter
control.
Backlight: Backlight mode to reduce darkening of
the center subject against lights
Standard: Standard mode
Spotlight: Spotlight mode to reduce blown-out
highlights on the center subject in the spotlight
Speed –99 to +99 (+50) Set the tracing speed of AGC and Auto Shutter
control.
AGC LMT
3 / 6 / 9 / 12 / 15 / 18 / 21dB
Set the maximum gain in AGC.
A.SHT LMT
1/100 / 1/150 / 1/200 / 1/250 /
1/500 / 1/1000 / 1/2000 /
1/5000 / 1/10000 / 1/20000 (for
1080/60i) or 1/16000 (for
1080/50i)
Set the maximum shutter speed in Auto Shutter
control.
ATW Speed
Setting for Auto Tracing
White Balance
1 / 2 / 3 / 4 / 5 Set the tracing speed of ATW.The larger number
you set, the speed becomes faster.
White
White gain offsets and preset
white color temperature
R Gain Offset
–99 to +99 (±0)
Set the R gain offset value. This setting is used
when the white balance adjustment mode is
Memory or ATW.
B Gain Offset
–99 to +99 (±0)
Set the B gain offset value. This setting is used
when the white balance adjustment mode is
Memory or ATW.
Preset White
2100 to 10000 (3200)
Set the preset color temperature in steps of 100K.
This setting is used when the white balance
adjustment mode is Preset.
Inversion
Inverting the picture
Off / H / V / H+V Set the inversion direction for when the picture is
inverted.
Off: Do not invert.
H: Invert in the horizontal direction.
V: Invert in the vertical direction.
H+V: Invert in both the horizontal and vertical
directions.
PICTURE PROFILE SET
Items Subitems and setting values Contents