23
REC
REC
REC
REC
4-5-2. Operating the Continuos Recording Mode (Use this mode for self record/playback check only)
1. Entering the continuos recording mode
1)Load the recordable disc to the unit.
The disc is loaded by pushing the tray.
2)Rotate the lAMSL knob to display “CREC MODE” (C31).
3)Press the YES button to change the display to “CREC MID”.
4)When access completes, the display changes the display to “CREC( ” and illuminates.
Note : The value of the “ ” displayed on the screen indicates the address of the recorded position.
2. Changing the parts to be recorded
1) Press the YES button during continuos playback to change the display as shown and move the played back part. disappears
during moving.
2)When access completes, the display changes to “CREC( ” and disappears.
Note : The value of the “ ” displayed on the screen indicates the address of the recorded position.
3. Ending the continuos recording mode
1) Press the MENU/NO button. The display changes to “CREC MODE” and disappears.
2) To eject the disc, press the A button.
Note 1: The playback start addresses for IN, MID, and OUT are as follows.
N : 40h cluster
MID : 300h cluster
OUT : 700h cluster
Note 2: The MENU/NO button can be used to stop recording anytime.
Note 3: Do not perform continuos recording for long periods of time above 5 minutes.
Note 4: During continuos recording, be careful not to apply vibration.
4-5-3. No-Volatile Memory Mode (EEP MODE)
This mode reads and writes the contents of the non-volatile memory.
It is not used in servicing. If selecting this mode accidentally, press the MENU/NO button immediately to exit it.
4-6. Functions of Other Buttons
Function name Main contents
N Sets continuos playback when pressed in the STOP state. When pressed during continuos playback, the tracking
servo turns ON/OFF. *Note
x Stops continuos playback and continuous recording
M The sled moves to the outer circumference only when this is pressed
m The sled moves to the inner circumstance only when this is pressed
SCROLL Switches between the pit and groove modes when pressed
PLAY MODE Switches the spindle servo mode (CLV S ↔ CLV A)
DISPLAY/CHAR Switches the display when pressed
A/OPEN/CLOSE Removes the disc
REPEAT Exits test mode
Note : If the continuos playback mode ends with the tracking servo OFF, the tracking servo is automatically turned on.
When the message “SERVO ON” appears at the end, press the x button to returns to the normal “mode” display.
"CREC MID" → "CREC OUT" → "CREC IN"
To Next Page
Loading...
Need help?
General
