30
Setting the reference
volume
You can set the reference volume level for
adjusting the volume by using (VOL) +/– on
both the monitor and the card remote
commander.
Press (POWER) and press (VOL) +/ – on
the monitor w hile no menu screen
appears.
The settable range is 0 to 47, and the default
setting is 10.
When you keep pressing down the button,
the value changes continuously.
Turning the image upside
dow n
To use the player in upright position, do the
following steps to turn the images on the
monitor upside down and switch the audio
channels.
Press (REVERSE) on the monitor.
“Reverse On” appears for 5 seconds and the
image on the monitor turns upside down.
To resume the normal images, press
(REVERSE) on the monitor again.
“Reverse Off” appears for 5 seconds.
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
