2-6. Inside Block
2-6-1. Inside Panel Assembly
Preparation
1. Remove the bottom panel assembly. (Refer to “2-5. Bottom Panel Assembly”)
Procedure
1. Open the SxS cover.
2. Remove the four screws and pull out the inside panel assembly in the direction of the arrow A.
3. Disconnect the flexible flat cable from the connector on the SWC-56 board and detach the inside panel
assembly.
4. Remove the AU cover.
SxS cover
A
AU cover
P2 x 5
Switch knobs
P2 x 5
P2 x 5
Inside panel assembly
Flexible flat cable
Connector
(SWC-56 board)
Slide switches
Note
When installing the inside panel assembly, fit the slide switches with the switch knobs.
5. Install the removed parts by reversing the steps of removal.
PMW-300
2-21
To Next Page
Loading...
