2-11-4. AXM-50 Board
Preparation
1. Remove the bottom panel assembly. (Refer to “2-5. Bottom Panel Assembly”)
2. Remove the inside panel assembly. (Refer to “2-6-1. Inside Panel Assembly”)
3. Remove the outside panel assembly. (Refer to “2-7-1. Outside Panel Assembly”)
4. Remove the rear panel assembly. (Refer to “2-8. Rear Panel Assembly”)
5. Remove the handle assembly. (Refer to “2-11-1. Handle Assembly”)
6. Remove the handle U-case assembly. (Refer to “2-11-2. Handle U-case Assembly”)
7. Remove the KSW-65 board. (Refer to “2-11-3. KSW-65 Board”)
Procedure
1. Remove the two screws (B2 x 5) to detach the microphone bracket.
PMW-300
2-37
To Next Page
Loading...
