1-10 (E)
PVM-A250
1-4-7. Speaker
. Remove the rear cover. (Refer to Section 1-4-1.)
8 Speaker holder
5 Harness
1 Two clampers
6 Conductive tape (SPEAKER)
9 Miniature speaker
7 Two screws
(BVTP3 x 10)
Conductive cushion
CN7000
Upper side
3 Two nylon rivets
4 Conductive tape
(BTM)
2 Wire saddle
3 Remove the tape.
Do not use the removed tape.
Replace it with the new tape.
Ferrite clamp
Tape Clamper
Serial No.7000001 to 7001869: PVM-A250 (SY)
Serial No.7200001 to 7200148: PVM-A250 (CN)
To Next Page
Loading...
