Sony PVM-A250 - 1-4. Disassembly Procedures

1-3 (E)
PVM-A250
1-4. Disassembly
n
. In this section, remove parts in the order of numbers shown in the figure.
. When removing/installing the cabinet and replacing the board, place the unit on the conductive cushion.
. QBC board is not prepared for spare parts. When the QBC board is broken, replace the OLED module
assembly.
1-4-1. Rear Cover
2 Handle
1 Two screws
(PSW4 x 16)
Conductive cushion
Upper side
4 Screw
(PSW4 x 8)
6 Screw
(PSW4 x 8)
8 Eleven screws
(PSW4 x 8)
3 Clamper
5 Stand block
7 Stand block