Menu Configuration and Basic Operation
64
1) Can only be displayed or configured if ENGINEER is selected as MODE on SECURITY MODE screen.
2) RCP-921 only.
3) Only enabled if CNS MODE in CNS SETTING is MCS.
4) Fixed at AUTO when AUTO NEGO is set to ON.
Items available for MENU CUSTOMIZE
Primary
menu
Secondary
menu
Operation/
adjustment item
Settings Function Factory default
CONDITION
(Continue)
TCP/IP
SETTING
1)
IP ADDR — Shows assigned IP address —
SUBNET MASK — Shows configured subnet mask —
DEFAULT
GATEWAY
— Shows configured default gateway —
Display Function Left adjustment knob Center adjustment knob Right adjustment knob
K N E E KNEE POINT SLOPE SAT
GAMMA GAMMA Rch Master Bch
F L A R E FLARE Rch Gch Bch
BLACK BLACK Rch Gch Bch
S T P G A M STEP GAMMA STEP
S H U T T E R SHUTTER SELECT SPEED
D E T A I L DETAIL LEVEL LIMIT CRISP
S A T SATURATION SATURATION
W H I T E WHITE Rch Gch Bch
C . T E M P COLOR TEMP BAL C.TEMP
P H A S E H/SC PHASE H COARSE H FINE SC
S K I N D T L SKIN DETAIL LEVEL
S D D T L SD DETAIL LEVEL LIMIT CRISP
A . I R I S AUTO IRIS LEVEL RATIO GAIN
S S M SUPERMOTION Flicer Reduce
M . W H I T E MASTER WHITE GAIN M.White Gain
(Blank) (No function assignment) — — —
To Next Page
Loading...
