Sony SRG-A40 - Page 84

84
SRT
This setting item is displayed when [Stream Setting] is set to [SRT-Caller] or [SRT-Listener].
Make settings related to SRT Streaming.
NDI|HX
This setting item is displayed when [Streaming Setting] is set to [NDI|HX].
Make settings related to NDI|HX Streaming.
Audio Port
Number
1024 to 65534 57000 Specify the transmission port number for audio data
used for RTSP unicast streaming.
Specify an even number in the setting range.
Two port numbers (the number specified here and an
odd num
ber with 1 added to the specified number)
are actually used for audio data communication and
control.
When performing simultaneous multi-transmissions,
a
different port number will be used for every
transmission, based on the port number specified
here.
Menu item Detail and setting
va
lue
Initial setting value
of the factory
default setting
Content
Destination ― ― When the streaming mode is [SRT-Caller], set the
de
stination URL.
Port Number 1024 to 65534 4201 When the streaming mode is [SRT-Listener], set the
port number for listening.
Latency 20 to 8000 120 Set the amount of delay from [20] ms and [8000] ms.
TTL 1 to 255 64 Set the TTL value from [1] to [255].
Encryption Off/AES128/AES256 Off Select the encryption method. Select from [Off],
[AE
S128], or [AES256].
Passphrase ― ― Set the passphrase used for encryption.
Press [Clear] to erase the entered passphrase.
ARC On/Off On Select the checkbox to enable the adaptive rate
c
ontrol function.
When the adaptive rate control function is enabled, it
is possi
ble to reduce the image interruption caused
by congestion of the communication line.
Menu item Detail and setting
va
lue
Initial setting value
of the factory
default setting
Content
License ― Invalid The installation status of the NDI license key is
displ
ayed.
Source Name ― ― NDI Source Name is displayed.
Group On/Off Off Enable the grouping function of NDI.
Group Name ― ― This setting item is displayed when the NDI grouping
f
unction is enabled. Set the group name.
Discovery Server 1 ― ― Set the NDI Discovery Server 1.
Discovery Server 2 ― ― Set the NDI Discovery Server 2.
Multicast Mode On/Off Off Enable multicast streaming.
Multicast Prefix 239.255.0.0 239.255.0.0 Display when [Multicast Mode] is enabled. Set the
pr
efix used for multicast streaming.
Multicast Netmask 255.255.0.0 239.255.0.0 Display when [Multicast Mode] is enabled. Set the net
mask that determines the range of multicast
addresses.
Multicast TTL 1 to 255 3 Display when [Multicast Mode] is enabled. Set the TTL
value for multicast streaming.
Menu item Detail and setting
va
lue
Initial setting value
of the factory
default setting
Content