122
US
D:\NORM'S JOB\SONY HA\SO0046\STR-DA3500ES\U VERSION\US\4144907111\01US-
STRDA3500ESUC\100REM.fm
masterpage: Left
STR-DA3500ES
4-144-907-11(1)
1 Select a channel you want to
preset.
For details on this operation, see
“Selecting channels from a category
(CATEGORY TUNING)”.
2 Press SHIFT and then press
ENT/MEM.
“MEM” lights up on the display window.
3 Press PRESET + or PRESET –
to select a preset number.
You can also select the number by
pressing the numeric buttons. Preset
numbers from 1 to 30 are available.
Channel 1 is preset for the preset numbers
when you purchase the receiver.
4 Press ENT/MEM.
5 Repeat steps 1 to 4 to preset
another station.
Selecting a preset channel
1
Press TUNER repeatedly to select
“XM RADIO” or “SIRIUS”.
2 Press PRESET+ or PRESET –
repeatedly to select the preset channel
you want.
You can also press SHIFT and then press
the numeric buttons to select the preset
channel you want. Then, press to enter
the selection.
You can also press TUNING MODE on the
receiver repeatedly to select “PRESET”,
then turn TUNING +/– to select the preset
channel you want.
Operating each
component using the
multi function remote
You can control Sony or non-Sony
components you are using with the multi
function remote supplied with the receiver.
The remote is initially set to control Sony
components.
When you change the settings of the remote
according to the components you are using,
you can control non-Sony and other Sony
components that the remote is initially unable
control (page 124).
1 Press the input button that
matches the connected
component that you want to
operate.
2 Press the appropriated buttons
to use the function listed in the
table below.
Note
You may not be able to operate some functions for
the components you are using.
Presetting satellite tuner
channels
Using the Remote
Operating the components
connected to the receiver
To Next Page
Loading...
