*
Models of area code U, CA only
** STR-DB1070 only.
CONTROL Al n hookup
l
If you have a CONTROL Al II compatible
Sony CD player, SACD player, tape
deck, or MD deck
Use a CONTROL Al cord (mini jack) (not
supplied) to connect the CONTROL Al II
jack on the CD player, SACD player, tape
deck, or MD deck to the CONTROL Al II
jack on the receiver. Refer to “CONTROL
Al II control system” on page 47 and the
operating instructions supplied with your CD
player, SACD player, tape
deck,
or MD deck
for details.
Note
If you make CONTROL A 1 II connections from
the receiver to an MD deck that is also connected
to a computer, do not operate the receiver while
using the “Sony MD Editor” software. This may
cause a malfunction.
2ND ROOM OUT**
l
If you have a Sony CD changer with a
COMMAND MODE selector
If your CD changer’s COMMAND MODE
selector can be set to CD 1, CD 2, or CD 3,
be sure to set the command mode to “CD 1”
and connect the changer to the CD jacks on
the receiver.
If, however, you have a Sony CD changer
with VIDEO OUT jacks, set the command
mode to “CD 2” and connect the changer to
the VIDEO 2 jacks on the receiver.
14
To Next Page
Loading...
Need help?
General
