Tip
- You can freely specify the time. After pressing
SLEEP, specify the time you want using the jog dial
and cursor buttons (< or >) on the receiver. The
sleep time changes in 1 second intervals. You can
specify up to 5 hours.
l
To check the remaining time before the receiver
turns off, press SLEEP. The remaining time
appears in the display.
The SET UP button allows you to make the
following adjustments.
1 Press SET UP.
2 Press the cursor buttons (< or >) to
select the parameter you want to
adjust.
3 Turn the jog dial to select the setting
you want.
The setting is entered automatically.
4 Repeat steps 2 and 3 until you have set
all of the parameters that follow.
Initial settings
Parameter Initial setting
6.1CH DECODING AUTO
MULTI CH (1 or 2) NONE
D.POWER ALWAYS ON
V.POWER AUTO OFF
SFIELD LINK ON
Al AUTO POWER ON
AUTO FUNCTION ON
2ND ROOM SP” OFF
COMMAND MODE*’ AVl
COLOR SYSTEM3
OSD4’
PAL
COLOR
OSD H.POSITION4’
4
OSD V.POSITION4’
4
1) Only when the center or surround back speaker is
set to “2ND ROOM” (STR-DB1070 area code U,
CA only).
2) Except for SIR-DB870 area code CEL.
3) SIR-DB 1070 of area code other than U, CA only.
4)
STRDB 1070 only.
G 6.lch Matrix (6.lCH DECODING)
According to the setting, the receiver decodes
and dowmnixes the surround back signals to
the surround speakers for 6.1 channel encoded
sources. This parameter lets you enjoy the
appropriate surround sound from the surround
channels.
You can set this parameter using 6.1CH
DECODING on the front panel.
When set
to
“AUTO”, the receiver performs
6.1 channel matrix decoding only if 6.1 channel
signals decode flag is ON.
When set to “ON”, the receiver performs
6.1 channel matrix decoding only if the
surround signals are 2 channel, regardless of the
6.1 channel decode flag.
When set to “OFF’, the receiver does not
perform 6.1 channel matrix decoding.
During “A.F.D.“, this parameter is always set to
“AUTO”, and you cannot change the setting.
When the 6.1 channel matrix decoding is
performed and the surround back speaker is set
to “NO”, you
can enjoy the surround back
signals with virtual 3D technology, even
without an actual surround back speaker (the
box
around SB does not light up). If the
surround back speaker is set to “YES”, the
surround back signals are output through the
actual speaker (SB and the box lights up).
n Multi channel assignment (MULTI
CH (for STRdBl070, MULTI CH 1 or
211
Lets you assign a function to MULTI CH (for
SIR-DB1070, MULTI CH 1 or 2). You cannot
assign TUNER or PHONO.
For STR-DB1070, you cannot assign the same
function to both MULTI CH 1 and 2.
continued
45
To Next Page
Loading...
Need help?
General
