If the factory settings of the FUNCTION
buttons do not match your system components,
you can change them. For example, if you have
an MD player and a tape deck and you do not
have a CD player, you can assign the CD/
SACD button to your tape deck.
Note that the settings of the TUNER and FN
SHIFT functions (VIDEO 1, VIDEO 2, VIDEO
3, PHONO and MD/TAPE) button cannot be
changed.
SONI?
I
AV I/&
l/O
Function
bunons
Numeric
buttons
ENTER
MASTER VOL -
Repeat the above procedure.
1
Hold down the Function button whose
function you want to change (for
example, CDBACD).
2 Press the corresponding button of the
component you want to assign to the
Function button (for example, 4 - Tape
deck).
The following buttons are assigned to select
the functions:
To onerate
Press
CD Dlaver 1
DAT deck
MD deck
2
3
TaDe deck A
4
Taoe deck B
5
LD
player 6
VCR (command mode
VTR
1 *) I
VCR (command mode VTR 2*1 8
VCR (command mode VTR 3*)
9
TV 0
DSS (Digital Satellite Receiver) >lO
DVD ENTER
VCD
player I44
* Sony VCRs are operated with a VTR 1.2 or 3
setting. These correspond to Beta, 8mm and
VHS respectively.
Now you can use the CDBACD button to
control the tape deck.
To reset a button to its factory
setting
To reset all the function buttons to
their factory setting
Press I/&, AV I/6 and MASTER VOL - at
the same time.
66
To Next Page
Loading...
