Speaker System Hookup
Speaker cords (not supplied)
One for each front, rear, and center speaker
;:; >m< ;:;
Monaural audio cord (not supplied)
One for an active sub woofer
Black u-0 Black
Front speaker (R) Front speaker(L)
IMPEDANCE
SELECTOR
FRONT
SPEAKE
Rear speaker(R) Rear speaker(L)
I I
Active sub woofer
I I
I I
-p T
o connect certain speakers to another amplifier
Use the PRE OUT jacks The same signal is output from both the
SPEAKERS jacks and the PRE OUT jacks For example, if you
want to connect just
the
front speakers to another amplifier,
connect that amplifier to the PRE OUT FRONT L and R jacks
Connect
the
To the
Front speakers (8 or 4’ ohm) SPEAKERS FRONT A terminals
Additional pair of front
speakers (8 or 4* ohm)
SPEAKERS FRONT B terminals
an
Rear speakers (8 or 4* ohm) SPEAKERS REAR terminals
l
Twist
the
stripped ends of the speaker cords about
2/3 inch (10 mm) Be sure to match
the
speaker cord to
the appropriate terminal on
the
components: + to + and
- to - If the cords are reversed, the sound will be
distorted and will lack bass
l
If you use front speakers with low maximum input
rating, adjust
the
volume carefully to avoid excessive
output on the speakers
Center speaker (8 or 4* ohm) SPEAKERS CENTER terminals
Active sub woofer SUB WOOFER PRE OUT*’
* See “Speaker impedance” on the next page
** You can connect an active sub woofer to either ofthe two jacks The
remaining jack can be used to connect a second active sub woofer.
16
To Next Page
Loading...
Need help?
General
