PRESET TUNING +/-
l
TUNlNGlPTY SELECT +/-*
FM/AM
TUNING +/-•*
DISPLAY 1 SHIFT
nmEhioRY FM ti0DE FEDS EON* FUN&ON
RDS PTY”
PRESET TUNING +/- buttons: Press to scan all preset
radio stations
DISPLAY button: Press to display the RDS information
II.lL.2
F
MEMORY button: Uses for memorizing preset stations
8.
5.
TUNlNGlPTY SELECT +/- buttons*: Press to scan all
d
available radio stations or select program types
TUNING +I- buttons**: Press to scan all available radio
P
stations
it
FUNCTION control: Rotate to select the tuner
RDS EON button*: Press to set the receiver to switch
stations automatically
RDS PTY button*: Press to scan preset stations by the
program type
FM MODE button: If “STEREO” flashes in the display
and the FM stereo reception is poor, press this button to
improve the sound You will not be able to enjoy stereo
effect but the sound will be less distorted
Note
If “STEREO” does not appear at all even when the FM broadcast
is received normally, press this button
to turn on the “STEREO”
indication
FM/AM button: Press to select the FM or AM band
Storing FM Stations
Automatically
(AUTOBETICAL)
This function lets you store up to 30 FM and FM RDS
stations in alphabetical order without redundancy
Additionally, it only stores the stations with the clearest
signals (This function is for models of area code CED
only)
If you want to store fiM or AM stations one by one, see
“Presetting radio stations” on page 46
For details on the buttons used in this section, see “Brief
descriptions of buttons used to receive broadcasts” on this
page
1
Press l/6 to turn off the receiver.
2 Hold down MEMORY and press I/& to turn the
receiver back on
“Autobetical select” appears in the display and the
receiver scans and stores all the FM and FM RDS
stations in the broadcast area
For RDS stations, the tuner first checks for stations
broadcasting the same program, then stores only the
one with the clearest signal The selected RDS stations
are sorted alphabetically by their Program Service
name, then
assigned a two character preset code For
more details on RDS see page 47
Regular FM stations are assigned two character preset
codes and stored after the RDS station
When done, “Autobetical finish” appears in the
display momentarily and the receiver returns to
normal operation
Notes
l
Do not press any of the buttons on the receiver or supplied
remote during autobetical operation
l
If you move to another area, repeat this procedure to store
stations in your new area
l
For details on tuning the stored stations, see page 46
l
The FM MODE setting is also stored along with the station
l
If you move the antenna after storing stations with this
procedure, the stored settings may no longer be valid If this
happens, repeat this procedure to store the stations again
SHIFT button: Press to select a memory page (A, B, or C)
for presetting radio stations or tuning to preset stations
* Models
of area
code CED only
**
Exceptfor models
of area
code CED
44
To Next Page
Loading...
Need help?
General
