Sony STR-DB940 User Manual

Preset Tuning
For details on the buttons used in this section, see “Brief
descriptions of buttons used to receive broadcasts” on
page 44
Before tuning to preset stations, be sure to preset them by
performing steps on “Presetting radio stations” below
1 Rotate FUNCTION to select the tuner.
The last received station is tuned in
2 Tune in the station that you want to preset using
Direct Tuning (page 45) or Automatic Tuning (page
45)
3 Press MEMORY
“MEMORY” appears in the display for a few seconds
Do Steps 4 to 6 before “MEMORY” goes out
4 Press SHIFT to select a memory page (A, B or C)
Each time you press SHIFT, the letter “A,” “B” or “C”
appears in the display
5 Press PRESET TUNING + or PRESET TUNING -to
select a preset number.
If “MEMORY” goes out before you press the preset
number, start again from Step 3
6 Press MEMORY again to store the station
If “MEMORY” goes out before you press the preset
number, start again from Step 3
7 Repeat Steps 2 to 6 to preset another station
To change a preset number to another station
Do Steps 1 to 6 to preset the new station to the number
Note
If the AC power cord is disconnected for about two weeks, all the
preset stations will be cleared from the receiver’s memory, and
you will have to preset the stations again
You can tune the preset stations either of the following
two ways
Scanning the preset stations
1
2
Rotate FUNCTldN to select the tuner.
The last received station is tuned in
Press PRESET TUNING + or PRESET TUNING -
repeatedly to select the preset station you want
Each time you press the button, the receiver tunes in
one preset station at a time, in the corresponding order
and direction as follows:
AluAZt* uAOtrBluB2cr crB0
Using the preset codes
Use the supplied remote to perform the following
operations For details on the buttons used in this section,
see the operating instructions for the supplied remote
1 Rotate FUNCTION to select the tuner.
The last received station is tuned in
2 For remotes without a display:
Press SHIFT to select a memory pare (A, B, or C),
then press the preset number of the station you
want using the numeric buttons on the supplied
remote
For remotes with a display:
Select the preset station you want from the list
displayed on the supplied remote when TUNER is
selected
46

Sony STR-DB940 Specifications

General

Type	AV Receiver
Impedance	8 ohms
Frequency Response	10Hz to 100kHz
Digital Inputs	3 (2 optical, 1 coaxial)
Surround Sound	Dolby Digital, DTS
Tuning Range	FM
Input Sensitivity	150mV (line)
Video Connections	Composite, S-Video