If you selected the tape deck
Do the procedure below to select a sound field
from the
Move
the easy
scroll key to display
the
information about
sound field list
Note that the sound fields contained in
deck A or B
each list will vary depending on the receiver
Note
Press SOUND FIELD
When the remote is programmed to control a non-Sony tape
deck, the following may occur:
-The information about deck B is not displayed and you
cannot switch between tape deck A and B
- “TAPE A/B” is displayed and tape deck A and B switch
automatically each time you press the easy scroll key, etc
The sound field list appears
If you selected the 2ND AUDIO source
Move
the easy scroll key to select the source of 2ND
AUDIO, then press the key
Move the easy scroll key to select the sound field,
E
then press the key to enter the selection
A display example
Note
Depending on the component you are using, “2ND AUDIO” may
not be displayed
Selecting a Sound Field
To turn off the sound field
Move the easy scroll key to select either “2CH STEREO”
or “A F D “ in the sound field list in the display
15
To Next Page
Loading...
Need help?
General
