Performing Several Commands in Sequence
Automatically (Macro Play)
Press FUNCTION
The function list appears
Move the easy scroll key to select “MACRO 1” or
“MACRO 2”. then press the key to enter the
selection
The IR codes appear in the display window as they are
performed
Notes
l
Pressing any of the following buttons during a macro play
operation will cancel the macro play sequence before it is
complete
- AV I/&
- l/O
- SYSTEM STANDBY
- SOUND FIELD
- FUNCTION
- SET UP
l
When the Macro Play function does not work properly, set
“WAIT TIME” between each operation
Other Operations
Each time you press a button on the remote, the backlight
turns on If you do the procedure below to turn off the
backlight, you can make the batteries last longer
Press SET UP.
The set up list appears
Move the easy scroll key to select “BACK LIGHT,”
then press the key to enter the selection
The BACK LIGHT list appears
Move the easy scroll key to select “ON” or “OFF,”
then press the key to enter the selection
aif
Be sure to turn on the receiver and point the remote
towards the receiver when performing the following
procedure
1 Press SET UP.
The set up list appears
2 Move the easy scroll key to select “ALL CLEAR”,
then press the key to enter the selection
3 Move the easy scroll key to select “YES”, then press
the key to enter the selection
“CLEAR OK?” appears
4 Move the easy scroll key to select “YES” again,
then press the key
All the contents of the remote’s memory (i e , all the
programmed data) are cleared
18
To Next Page
Loading...
Need help?
General
