36
US
C:\Documents and
Settings\pc13\Desktop\JC060000_2667347112DG900_US\2667347112\US03CON_STR-DG900-
U.fm
masterpage: Left
STR-DG900
2-667-347-11 (2)
1 Press AMP and then press
MENU.
“1-LEVEL SET” appears on the display.
2 Press control button V/v
repeatedly to select “8-AUTO
CAL SET”.
3 Press the control button or
control button b to enter the
menu.
“A. CALIBRATION” appears on the
display.
4 Press the control button or
control button b.
5 Press control button V/v
repeatedly to select “AUTO
CAL YES”.
6 Press control button to perform
the calibration.
The following appears on the display.
AUTO CAL [5] t AUTO CAL [4] t
AUTO CAL [3] t AUTO CAL [2] t
AUTO CAL [1]
The table below shows the display when
measurement starts.
When measurement ends, “COMPLETE”
appears on the display and the settings are
registered.
Notes
• Auto Calibration cannot detect the sub woofer.
Therefore, all sub woofer settings will be maintained.
• You cannot select Auto Calibration when
headphone is connected.
• The measurement process will take a few minutes
to complete.
Tips
• When Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
–Press ?/1, input buttons or MUTING (or turn
INPUT SELECTOR or press HDMI button on
the receiver).
– Change the volume level.
Error codes
When an error is detected during Auto
Calibration, an error code will appear on the
display cyclically after each measurement
process as follows:
Error code t blank display t (error code t
blank display)
a)
t PUSH ENTER
a)
Appears when there are more than one error code.
To rectify the error
1 Record down the error code.
2 Press the control button.
3 Press ?/1 to turn off the receiver.
4 Rectify the error.
For details, see “Error code and remedies”
below.
5 Turn on the receiver and perform Auto
Calibration again (page 35).
Measurement for Display
Environment noise level NOISE CHECK
Speaker connection MEASURE SP DET.
Speaker level MEASURE GAIN
Speaker distance MEASURE DIST.
Error and warning codes
US01COV_STR-DG900-U.book Page 36 Wednesday, April 26, 2006 12:15 PM
To Next Page
Loading...
