Note
If the tuned frequency is invalid or out of range, [---.-- MHz] appears and then the screen returns to
the current frequency.
Make sure you have entered the right frequency. If not, repeat steps 3 and 4. If you still cannot tune
to a station, the frequency may not be in use in your area.
Hint
The tuning scale for direct tuning is shown below:
USA and Canadian models
100 kHz
Other models
50 kHz
[56] Enjoying Video and Sound Listening to the radio
Receiving RDS broadcasts (for European and Asia-
Pacific models only)
This receiver allows you to use Radio Data System (RDS), which enables FM radio stations (*)
to send additional information along with the regular programming signal. This receiver offers
convenient RDS features, such as Program Service name display.
Note
RDS may not work properly if the station you tuned to does not transmit the RDS signal or if the
signal strength is weak.
Some letters that can be displayed on the TV screen cannot be displayed on the display panel.
Hint
You can check the frequency while a Program Service name is displayed by pressing DISPLAY
Press .
2
Enter the frequency.
3
Press
/ to change the digit on the display panel.
1.
Press to move to the next digit.
You can move the input position backward and forward by pressing
/ .
2.
Repeat step 3 until the desired frequency is displayed.
4
Not all FM stations provide RDS service, nor do they provide the same type of services. If you are not familiar
with the RDS services in your area, check with your local radio stations for details.
*
Select [Listen] - [FM] from the home menu.
1
Select a station.
When you tune to a station that provides RDS services, the Program Service name
appears on the display panel.
2
To Next Page
Loading...
