Follow the procedure below after connecting the speakers installed in Zone 3 to the
SURROUND/ZONE 3 terminals of the receiver.
1. Select [Setup] - [Speaker Settings] from the home menu.
2. Select [Speaker Pattern].
3. Select one of the following speaker patterns displayed on the TV screen:
3/0.1, 3/0, 2/0.1 or 2/0, and select [Save].
4. Select [Surround SP Assign] - [Zone3].
Note
You cannot set the SURROUND/ZONE 3 terminals for a Zone 3 connection if a speaker
pattern with surround speakers is set.
[108] Using the Multi-Zone Features (for STR-DN1060 only)
Enjoying sound from
speakers located in other rooms (for STR-DN1060 only)
4. Enjoying sound in Zone 2 and/or Zone 3 (for STR-
DN1060 only)
You can enjoy sound from the receiver in Zone 2 and/or Zone 3 by the following procedure.
1. Press ZONE SELECT on the receiver repeatedly to select Zone 2 or Zone 3.
2. Press ZONE POWER on the receiver.
The selected zone is activated.
3. Select the source signals you want to output using INPUT SELECTOR on the receiver
while [2. xxxx (input name)] or [3. xxxx (input name)] is shown on the display panel.
Select [SOURCE] if you want to listen to the same sound as main zone in Zone 2 or
Zone 3.
4. Start playing the desired audio content on the selected input device.
5. Adjust to a suitable volume.
Adjust the volume using MASTER VOLUME on the receiver while [2. xxxx (input
name)] or [3. xxxx (input name)] is shown on the display panel.
Hint
To Next Page
