BVM-A14
4-5
3. MATRIX adjustment (1)
Adjustment Operation Standard Adjusting Point
Step 1
. Input the SMPTE 240M (1035/60i) The output waveform of TP121 (RED) is flat: The adjustment menu is
8-color bar signal (saturation: 100%) to Level difference: 0 ± 4 mV PR R GAIN
BKM-62HS (HD SDI/SDI input adaptor). in SYSTEM CONFIGURATION →
. Set MATRIX in the INPUT CONFIGU- MAINTENANCE → VIDEO (2/5).
RATION menu to SMPTE240M.
. Set Y G GAIN to “853”.
. Connect the oscilloscope to TP121
(RED).
Step 2
. Connect the oscilloscope to TP321 The output waveform of TP321 (GREEN) is flat: The adjustment menu is
(GREEN). Level difference: 0 ± 10 mV G PR GAIN
G PB GAIN
in SYSTEM CONFIGURATION →
MAINTENANCE → VIDEO (2/5).
Step 3
. Connect the oscilloscope to TP521 The output waveform of TP521 (BLUE) is flat: The adjustment menu is
(BLUE). Level difference: 0 ± 10 mV PB B GAIN
in SYSTEM CONFIGURATION →
MAINTENANCE → VIDEO (2/5).
Make it flat.
Make it flat.
Make it flat.
. Set MATRIX in the INPUT CONFIGURATION menu to ITU709. Change the input signal to ITU-R BT.709 (1080/60i),
and adjust steps 1 to 3.
. Set MATRIX in the INPUT CONFIGURATION menu to ITU601. Change the input signal to ITU-R BT601 (480/60i),
and adjust steps 1 to 3.
To Next Page
Loading...
