Sony Trinitron KV-13VM20 - Page 42

Quick Timer Recording
This function is convenient when, for example, you want to set the VCR to start
“recording immediately without going through the whole timer setting procedure.
* Make sure that the clock is set correctly before you activate Quick Timer Recording.
« During Quick Timer Recording, you cannot change the channel on the VIDEO TV.
1 Insert a cassette. The VIDEO TV automatically turns on.
2 Press INPUT SELECT so that a channel number appears.
Press TAPE SPEED to select the recording speed, SP, LP or EP.
| Notes | Select the desired channel number with the 0-9 buttons and ENTER or
= 3 CHANNEL +/-.
* To extend the Quick Timer Recording \f you try to select the Cable TV channel, first set CABLE to ON in SET UP
time, press LENGTH to advance the menu.
recording time in 30-minute increments.
+ To clear the Quick Timer Recording ;
‘setting, press LENGTH and START at the 4 Repeatedly press START on the front panel to preset the start time.
same time.
START
* tf you try the Quick Timer Recording
immediately without setting the start time,
delete the step 4.
* If the tape runs out during Quick Timer aa ae aoa
Recording, recording will stop and the LENGTH = 0:00
power goes off. The tape will not rewind
automatically.
* If a power interruption occurs during
Quick Timer Recording, recording will
stop and the power goes off. if the power
interruption lasts less than three hours 5 Press LENGTH on the front panel to set the recording time which appears on
and the power is restored before the the screen.
recording end time, recording will start Each time you press LENGTH, the time length advances in 30-minute
again from that point. increments up to 9 hours.
LENGTH s
QUICK TIMER
START TIME 12:30 AM
LENGTH 0:30
6 Press POWER to turn off the VIDEO TV.
The VCR turns on at the preset time and starts recording, then stops at the preset time.
42 Chapter 5 : Using Advanced VCR Features