Sony Trinitron KV-13VM20 - Chapter 1: Setting up; Connecting TV Antenna;Cable

2
chaatsk 1: Setting Up
Connecting TV Antenna/Cable
Although you can use either an indoor of outdoor antenna with the VIDEO TV, an outdoor antenna will provide you with better
picture quality. You can receive cable TV by connecting a cable supplied by your local cable company.
Connecting VHF, UHF or VHF/UHF Combination Antenna, or CATV Cable
75-ohm coaxial cable (round) 300-ohm twin-lead cable (flat)
1 Check your antenna cable type and prepare the end of Check your antenna cable type and prepare the end of
the cable using the F-type connector. . the cable using the 300-ohm twin-lead cable.
-~ Attach an F-type connector (not supplied). Attach the supplied antenna connector.
= Loosen both
a ne screws on the
connector with
screwdriver.
a
{
Attach the cable
and tighten both
screws with a
3mm(1/8inch)
Cc
=
:
y=
screwdriver.
d
——
rb
:
Plug
the
connector
into
the
VHF/UHF
terminal
at
the
Plug
the
connector
into
the
VHF/UHF
terminal
at
the
:
rear of
the
VIDEO
TV.
rear
of
the
VIDEO
TV.
|
|
(Rear
of
TV)
(Rear
of
TV)
VHF/UHF Ce VHF/UHF
* Most combination antennas are equipped with a signal
splitter. ;
Remove the splitter and attach the appropriate
connector.
8 Chapter 1: Setting Up