DBS Connections (continued)
Connecting a DB$ (Direct Broadcast
Satellite) receiver and a VCR
1 Connect the cable from your satellite
antenna to your DBS receiver•
2 Attach the coaxial connector from your
cable or antenna to VHF/UHF IN on your
VCR.
3 Using a coaxial connector, connect
VHF/UHF OUT on your VCR to
VHF/UHF on your TV.
4 Using A/V connectors, connect AUDIO
and VIDEO OUT on your DBS receiver to
AUDIO and VIDEO IN on your VCR.
5 Using A/V connectors, connect AUDIO
and VIDEO OUT on your VCR to AUDIO
and VIDEO IN on your TV.
Disconnect all power sources before making any connections.
For optimum picture quality, use S VIDEO instead of
the yellow AN cable. S Video does not provide sounc
your audio connectors must still be connected.
DBS receiver
VMC-810S/820S (not supplied)
I VCR _ I
(Rear of TV)
t
VMC-810S/820S (not supplied)
iv_o
EAUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
Note
• To view from the DBS or VCR, select the
video input to which your DBS receiver or
VCR is connected by pressing TV/VIDEO
on the remote control.
: 9
To Next Page
