: Operating a cable box or DBS receiver
Programming the remote
You can program the supplied remote control
to operate a cable box or DBS receiver.
1 Press CODE SET.
2 Press DBS/CABLE (FUNCTION).
3 Use the 0-9 buttons to key in the
manufacturer's code number from the
following chart.
4 Press ENTER.
For more details on operating the
cable box or DBS receiver
Refer to the operating instructions that were
supplied with the equipment.
If the remote control doesn't work
• First, try repeating the setup procedures
using the other codes listed for your
equipment.
Tips "_"
• lfmorethanonecodenunlberislisted, tryentering
them one by one until you come to the correct code for
your equipment.
• lfyouenteranewcodenumber, thecodemmrberyou
previously entered at that setting is erased.
• hTsomerarecases, youmaynotbeablctooperate
your equipment with the sltpplied remote control h_
thia case, use the equipment's own remote cotttrol
llllit,
• Whenever you remo_" the l_tteries the code numbers
may revert to the factory settiog and must be tz'set.
Manufacturer code numbers
(cable box)
Manufacturer Code
Hamlin/Regal 222, 223, 224,225, 226
Jerrold/G. 1. 201, 202, 203, 204, 205, 206,
207, 208, 218
Oak 227,228, 229
Panasonic 219, 220, 221
Pioneer 214, 215
Scientific Atlanta 209, 210, 211
Tocom 216, 217
Zenith 212,213
Manufacturer code numbers
(DBS receiver)
Manufacturer
Sony
General Electric
Hitachi
Hughes
Panasonic
RCA/PROSCAN
Toshiba
Code
801 (preset code for
remote control)
8O2
8O5
8O4
8O3
802, 808
806, 807
28
To Next Page
