Connecting and Installing the TV (continued)
Cable Box Connections
Some pay cable TV systems use scrambled or
encoded signals that require a cable box* to
view all channels.
Cable box
1 Connect the coaxial connector from your
cable to the IN on your cable box.
2 Using a coaxial cable, connect OUT on
your cable box to VHF/UHF on your TV.
Cable box and cable
• KV-27S65,27V65only
For this set up, you can switch between
scrambled channels (through your cable box),
and normal (CATV) channels by pressing
ANT on your remote control.
Notes
• Your Sony remote control can be
programmed to operate your cable box.
(see page 28)
• When using PIP, you cannot view the
window picture with the AUX input.
I fyouwillbecontrollingaflchannelselection I
throughyour cablebox, youshouldconsiderusing
the CHANNELFIXfeature discussedon page23.
(Rear of TV)
(;able VHF/UHF
iN I--_ OUT
*Cablebox
If you are connecting a cable box through the AUX input and would I
like to switch between the AUX and normal (CATV) input you should
consider using the CHANNEL FIX feature discussed on page 23.
*Cable box (Rear of TV)
scrambleo VERTE
7S-ohm coaxial v
(signal)
cable (not supplied) VHF/UHF°
CATV cable
(unscrambled channels)
6
To Next Page
Loading...
